Are you looking for HP Officejet 8600 printer. Do you want to system problem on your printer? Simple steps below to fix ink system failure problem As soon as the printer turns on, press the button (the arrow icon) on the front panel of the printer.
Perform a power reset
1.Turn on the printer, if it is not already on.
2.Wait until the printer is idle and silent before you continue.
3.With the printer turned on, disconnect the power cord from the rear of the printer.
4.Wait at least 30 seconds.
Take the cartridge out of the printer
Politely remove the tape from the left corner and tape over the contact squares on the top right corner.
Now place the cartridge back to its place and run another alignment page.
Now gently remove the reinsert the cartridge, remember this time no tape should be there on any of the contacts.
Now check that if the printer recognizes the cartridge as being full.
Repeat the above steps if the cartridge is still showing as being empty.
This time, use the bottom corner contact squares instead of the top ones. If you are still unable to reset the cartridges, using multiple cartridges is likely the only way to do it.
Hope this helps.
Bruce